Why You Must Schedule A Roy Mold Inspection Service Today
Have you recently discovered the growth of mold in your Roy home? Perhaps it had silently been growing in the attic, basement, or even in your bedroom? If so, this is a situation you need to deal with immediately. In some cases, you may be able to deal with mold yourself, using the proper do-it-yourself methods, however, larger areas are going to need professional treatments.
To understand exactly what you are dealing with in your home as well as the treatment and repairs that will be needed, your home is going to need to undergo a mold inspection by a qualified professional in Roy. It is important to understand that there are several mold inspectors in the Roy area, however, you should not be tempted by choosing the one with the lowest cost. This is a potentially serious and dangerous situation and you want the best you can afford for your home and family.
Understanding Roy Mold Inspection Services And Companies
Mold inspection helps to identify conditions around your property that may help to support the growth of mold as well as pinpoint those specific problem areas in your home or business. The mold inspector is going to take the time to investigate the interior and exterior of the property to examine any signs of water damage or leaks as well as the source such as a leaking pipe, cracked wall, or a broken gutter.
What Does A Mold Inspector Do During The Inspection?
Once a visual overview has been done, the first job is to accurately gauge the level of moisture in the property. Moisture levels will be measured at intervals of about two feet and special attention is always monitored around water heaters, sinks, and anywhere that a water source is located. The moisture levels will be read using a special meter that has two pins that are inserted into the lower part of the wall and help to obtain an accurate moisture reading. An acceptable range would be in the area of 15% or lower.
If during the initial part of the inspection finds that the moisture level is greater than 15% or there are extensive signs of water damage or mold growth, the inspector will bring it to your attention and offer up some primary actions you can take. Even if the inspector finds visible signs of mold growth, they will be able to give any conclusive indications until sampling is taken for further investigation.
In most cases, the inspector will take an air sample. Air samples allow the technician to find out what specific strain of mold is present in the air if any, and to what level. During this part of the process, the technician will typically take two air samples. The first sample will be from a specific problem area, while the other is from an outside source. Many people are confused as to why a second sample is taken from the outside, the answer is quite simple. Mold can be found all over the place and in many cases, it is 100% safe and does not harm us. Through the mold inspection process, it must be established if the mold that is found inside the home or business is the same type of strain that is found outside and to what ratio. In addition, the mold may be the same, however, it could be a much higher concentration and we need to understand why. And of course, we must also decipher if it is a toxic mold.
If you are concerned about mold in your home or business, it is best to call a local Roy mold inspection service. Bio Clean is standing by to ensure the safety and health of your family, so please call us today to schedule an inspection!